|
Post by kcatthedog on Apr 4, 2018 14:54:04 GMT -6
If you were trying to measure the transient response for two different pre amplifiers, what's the right way to do that ?
Do freq by time graphs demonstrate much of anything ? I would think them a crude measure at best as transients are inherently fast ?
|
|
|
Post by wiz on Apr 4, 2018 15:11:39 GMT -6
If you were trying to measure the transient response for two different pre amplifiers, what's the right way to do that ? Do freq by time graphs demonstrate much of anything ? I would think them a crude measure at best as transients are inherently fast ? Until someone smarter chimes in.... You can listen obviously, and put transient heavy stuff through, like snare drums If you have a Oscilloscope you could put a square wave into the preamp and look at that.. cheers Wiz
|
|
|
Post by EmRR on Apr 4, 2018 16:10:22 GMT -6
Stepped (10 dB changes) square wave source is I believe one standard method. Illustrates any reaction to change between the two. Or maybe I'm thinking of compressors; anyway, it would work.
|
|
|
Post by notneeson on Apr 4, 2018 18:55:33 GMT -6
If you were trying to measure the transient response for two different pre amplifiers, what's the right way to do that ? Do freq by time graphs demonstrate much of anything ? I would think them a crude measure at best as transients are inherently fast ? Ah man, don't sweat that Purple thread. Does anything actually sound wrong in those dropbox samples? I did not particularly notice any huge lack of transient detail. That said, I don't really get much out of other people's mic pre tests, got to get my hands on 'em.
|
|
|
Post by kcatthedog on Apr 4, 2018 18:58:58 GMT -6
Oh ya I hear you! I poster here cus then I was curious ,what is the right way to test for differences?
|
|
|
Post by svart on Apr 4, 2018 18:59:59 GMT -6
If you were trying to measure the transient response for two different pre amplifiers, what's the right way to do that ? Do freq by time graphs demonstrate much of anything ? I would think them a crude measure at best as transients are inherently fast ? Ah man, don't sweat that Purple thread. Does anything actually sound wrong in those dropbox samples? I did not particularly notice any huge lack of transient detail. That said, I don't really get much out of other people's mic pre tests, got to get my hands on 'em. After years of sweating other's opinions, I finally settled down too. I spent years thinking that I was hearing things "wrong" before I made the realization that maybe I was actually the person hearing "right"..
|
|
|
Post by jimwilliams on Apr 5, 2018 9:57:35 GMT -6
Use a 2k hz square wave. That's a standard frequency as used by Jensen and others. If you see a slope reduction on the rising edge that's the transients getting missed.
If 2k looks good then try 10k hz. Only a few will pass that unaffected.
|
|