|
|
Post by kcatthedog on Oct 21, 2017 17:58:15 GMT -6
home depot sells pine made into 20x96 planks these are 19x28 so 94 inches total going to pt my delta on top of these and have them off to my left hand side ! before and after click on pics to see them correctly ! Attachment Deleted |
|
|
|
Post by winetree on Oct 21, 2017 18:53:22 GMT -6
Never thought of hanging the racks from the ceiling.
|
|
|
|
Post by kcatthedog on Oct 21, 2017 19:59:28 GMT -6
wiz tells me its very hip in oz !!
|
|
|
|
Post by kcatthedog on Oct 21, 2017 20:04:32 GMT -6
|
|
|
|
Post by indiehouse on Oct 24, 2017 12:25:22 GMT -6
Very cool. Exactly what I need to do. Did you go off of any plans? Total cost?
|
|
|
|
Post by kcatthedog on Oct 25, 2017 5:38:07 GMT -6
No, made it up in my head, Under $200 cdn for both and I bought new raxxass rack rails
just made the plans up by measuring from my current set up, so 28x19 with 14 u steel rails. 2 packs of 2 were about $100 cdn
the 20x96 prepared pine boards were about $65 cdn
2x2x8 pine for internal joint braces were like $10 bucks each
wheels were $4-5 each
The running length is 94 inches so you have a bit of room to spare for the cuts.
Lessons learned:
cut 19 a little wide (2-4/16ths)to better accommodate faceplates.
I screwed mine from the outside for speed but you could screw from the inside so outside face is clean.
I put in the top front horizontal brace but you don't really need it , you could have two 10-15 inches braces along the top inside edge going front to back, this would likely allow 16 r
for bottom, remember that you do not want to start the angle from the bottom corner, as this leaves no room for the bottom piece to angle down so becomes wasted space. I notice in pro builds, the bottom 3-4 inches is squared off, so it looks like a base, nice for the wheels etc, then the front face angles up (so faceplates are angled up towards you), this angle starts 3-4 inches up and you cuts out a pie shaped wedge.
I just used the rack rail to visualize how steep I wanted this angle, so cut away about a 4 inch wedge at top, could have gone a little deeper, if I wanted angle higher.
I'll post a pick of making this cut.
All done in a day !
|
|
