|
|
Post by peterhess on Apr 19, 2024 9:42:31 GMT -6
Anyone out there build one of these? I have a couple questions. Thanks! P
|
|
|
|
Post by keymod on Apr 19, 2024 10:43:44 GMT -6
I built a pair
|
|
|
|
Post by peterhess on Apr 20, 2024 6:48:01 GMT -6
The T1 transformer front side has only 7 pads on the reverse: assembly guide says to solder all 26 pins (counting header pins on both sides of the transformer), but with no pad on 6 of them, it seems I should only solder the 7 and leave the rest untouched?
|
|
|
|
Post by keymod on Apr 20, 2024 11:50:39 GMT -6
It's been a while, so let me check later on this weekend. Sorry for the delay. You can probably get a quicker answer from Jean-Pierre at Sound Skulptor directly.
|
|
|
|
Post by peterhess on Apr 20, 2024 14:36:45 GMT -6
Thanks for looking! JP hasn’t replied to me yet, I emailed him direct last week.
|
|
|
|
Post by anders on Apr 20, 2024 15:16:32 GMT -6
I built 2, but it is a while ago. I seem to remember I didn't bother with the non-pad pins.
By the way, i messed up the orientation of U6 on one of them. Not recommended.
He even put in "the small coil must face towards Q4" in the instructions, but I thought I knew better. I didn't. It did survive though.
Nice sounding units.
|
|
|
|
Post by keymod on Apr 21, 2024 12:12:32 GMT -6
I only soldered where there was a pad.
|
|
|
|
Post by peterhess on Apr 24, 2024 21:32:29 GMT -6
Thanks! That seems to be the only thing to do.
|
|
