|
|
Post by Ward on Sept 22, 2018 7:56:39 GMT -6
12 years later and my C24 has seen constant daily use... until today, a member of the band I'm producing accidentally knocked out the IEC cord too the power supply from the floor outlet, and after rebooting, it failed to connect to protools. The sub-mixer, monitor controls and all other analog functions connected fine but the display reads "OFFLINE". Anyone have any ideas? Much appreciated in advance. jimwilliams? @hemetech? Anyone? |
|
ericn
Temp
Balance Engineer
Posts: 15,014 
Member is Online
|
Post by ericn on Sept 22, 2018 9:16:36 GMT -6
No real ideas but do try shutting down the whole pt rig and rebooting everything m?
|
|
|
|
Post by Ward on Sept 22, 2018 9:54:30 GMT -6
No real ideas but do try shutting down the whole pt rig and rebooting everything m? Don't that several times, but finally found the issue!! The ethernet cable on the console end had one wire broken loose from the impact. Off to Best Buy I go for a new gigabit ethernet cable. Yay, unexpected expense. And lost time. |
|
ericn
Temp
Balance Engineer
Posts: 15,014
Member is Online
|
Post by ericn on Sept 22, 2018 11:05:28 GMT -6
No real ideas but do try shutting down the whole pt rig and rebooting everything m? Don't that several times, but finally found the issue!! The ethernet cable on the console end had one wire broken loose from the impact. Off to Best Buy I go for a new gigabit ethernet cable. Yay, unexpected expense. And lost time. Cheaper and easier than it could be! You don’t have a back up cable ? Ward have I not taught you Eric’s first rule of life? Always have a back up! Why I am off to five Below kid grabbed last backup lightning cable and HDMI cable. Always have a backup! |
|
|
|
Post by Ward on Sept 24, 2018 6:19:56 GMT -6
All good now, and now I have another backup. I had a backup, and leant it to someone . . . and never got it back. Story of my life
|
|
