|
Post by jin167 on Dec 4, 2015 20:58:27 GMT -6
Hello, everyone. Sorry to begin my first post with a question but I am in a very frustrating situation here so please do bear with me..
I'm an owner of a flamingo vintage and recently I came to realise that it is time to replace the tube inside mine as it was making too much noise.
Initially, I thought that I would need to send the mic back to violet design to have the tube replaced but after reading some posts about replacing the tube inside flamingo on the purple site I came to realise that it might be possible to replace the tube myself.
I tried to open the mic but the screws at the bottom were too tight and I'm not sure what I can use to turn those screws.
Anyone ever saw a screw like those?
If you have, then please share your knowledge with me...
Here are some pics:
|
|
|
Post by Johnkenn on Dec 4, 2015 21:13:43 GMT -6
|
|
|
Post by jin167 on Dec 4, 2015 21:17:09 GMT -6
Nice! Never seen a screw like that before Thank you so much Johnkenn I'll have a look around and see if I can find one lying around in the house!
|
|
|
Post by Johnkenn on Dec 4, 2015 21:20:23 GMT -6
I hadn't either. Apparently called a "spanner screwdriver". Welcome!
|
|